Installation Guide

Page 3 / 5
Function and Operation
MODES OF OPERATION
Choose a mode by sliding the switch on the bottom of the sensor of the
fixture. (See FIG.7 on page 3)
Note: When power is first applied, the light will be turned on
immediately. Wait for 60 seconds to allow the sensor to warm up.
1. TEST MODE (daytime and nighttime operation.)
The wall wash lights will brighten when the switch located on “TEST” position. The sensor will turn the heads light
on automatically when motion is detected, and stays on as long as the motion is continuing. After about 5 seconds
of motion is no longer detected, the heads light will turn off automatically.
2. OFF MODE (nighttime operation only; on at dusk, off at dawn)
In the night, the sensor will turn all lights on automatically when motion is detected, and stays on as long as the
motion is continuing. When the motion stops, the lights will remain on for the predetermined time as you set (5 or
180 seconds), then all lights will turn off automatically.
Lights will turn off automatically at dawn.
3. AUTO MODE (nighttime operation only; on at dusk, off at dawn)
Wall wash light will turn on at dusk and turn off at dawn automatically. Heads light turn on automatically when
motion is detected and stays on as long as the motion is continuing. When the motion stops, the heads light will
turn off automatically after the predetermined time as you set up (5 to 180 seconds).
Lights will turn off automatically at dawn.
FIG. 3
Adjustment Sensor Lower
For Short Coverage
Adjustment Sensor Higher
For Long Coverage
FIG. 4
FIG. 5
Adjusting Handle
Collar
140613
sensor
Clamp Screw
Collar
Ball Joint
FIG.1
FIG. 2
sensor
1. Loosen the clamp screw in the sensor ball joint and gently rotate
the sensor. (See Fig. 1)
2. Walk through the coverage area noting where you are when the
lights turn on (also, the LED will flash several times when motion
is detected). You can rotate the sensor head up and down, left
and right to change the coverage area. (See Fig. 1 and Fig. 2)
3. Adjust the range as need, range set too high may increase false
triggering. (See Fig. 3 and Fig. 4)
4. Secure the sensor head by tightening the clamp screw. Do not
overtighten the screw.
5. Adjust the LED light heads to left or right by loosening the collars,
then loosen the adjusting handle to adjust the light head to the right
angle he prefer. After that, please tighten the adjusting handle and
the collar. But do not rotate the LED light heads more than 270°
from the original setting. (See Fig. 5)
6. Adjust the LED light heads to up or down by loosening the
adjusting handle. (See Fig. 5)
7. Keep the LED lights at least 1” (25mm) away from the sensor.
Do not allow the LED light heads to block the lens.
Motion Sensor and LED Light Head Adjustment
______________________________________________