Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0108
1.Attach the threaded pipe to the mounting strap, then secure it with a washer and hex nut.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
150113
Mounting Screw (B)
Wire Nut (E)
Mounting Strip (A)
End Cap(F)
Bulb Type A Max.100W
(not included)
Mounting Screw (B)
Mounting Strip (A)
Green Grounding Screw (C)
Wire Nut (E)
House Grounding Wire
Washer(H)
Fixture Grounding Wire
Threaded Pipe(D)
Outlet Box
Fixture Wire
End Cap(F)
Fixture
Photocell
Hex Nut(G)
Hardware Package (included):
Green Grounding
Screw (C)
Threaded Pipe (D)
T
Turn off the power at fuse or circuit box.
Installation Steps
Hex Nut (G)
Washer (H)
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.