Installation Guide

1. Install bulb(not included). See relamping label at socket area or packaging for maximum allowed wattage.
2. Attach the metal frame to the holder and secure it with four set screws.
3. Pull out the source wires from the post. Make wire connections using wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the post
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the post
---Attach the fixture grounding wire (usually green insulation or bare wire) to the grounding wire from the post.
Carefully put the wires back into the post.
4. Place the fitter on the post, then secure it with the fitter screws.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
T0113
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Bulb Type A Max.100W
(not included)
Wire Nut (B)
Fitter Screw (A)
Hardware Package (included):
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box
Installation Steps
Metal Frame
Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter Screw(A)
Socket
Photocell
Fitter
Holder
Set Screw
150110
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.

Summary of content (2 pages)