Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0118 / T0121
Cover
Socket
141222
Wire Nut (B)
Metal Frame
Set Screw
Clip
Clip
Post Grounding Wire
Fixture Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter
Fitter Screw (A)
Bulb Type B Max.60W
(not included)
Fitter Screw (A)
Photocell
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
1. Take a glass panel and gently slide it into the metal frame in place,
secure it by pressing two clips on top side of the metal frame and
two clips on the bottom of the metal frame. Repeat with the other
glass panels. (See Figure 1)
2. Pull out the source wires from the post. Make wire connections using
wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the post
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the post
---Attach the fixture grounding wire (usually green insulation or bare wire) to the grounding wire from the post.
Carefully put the wires back into the post.
Fig. 1
Metal Frame
Glass Panel
Clip
Glass Panel
Hardware Package (included):
Turn off the power at fuse or circuit box.
Installation Steps
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.