Installation Guide

ManualsBrandsCascadia ManualsLighting & Ceiling FansCadiz 60-Watt 19.25-in Oil Burnished Bronze Craftsman Post Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0139

Dome

Socket

Glass Holder

141124

Wire Nut (B)

Metal Frame

Set Screw

Post Grounding Wire

Fixture Wire

Wire Nut (B)

Post

Fitter

Fitter Screw (A)

Bulb Type A Max.60W

(not included)

Fitter Screw (A)

Photocell

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

1. Install bulb (not included). See relamping label at socket area or

packaging for maximum allowed wattage.

2. Attach the inner glass shade to the glass holder and turn it clockwise

until it locks in place.

Note: Do not over tighten.

3. Place the outer glass shade into the metal frame carefully, and then secure it by pressing the clips from the top sides.

(See Fig.1)

Note: Slide the outer glass shade downward into the notch inside of the metal frame.

4. Screw the loop onto the nipple. Attach the dome to the metal frame, then secure it with two set screws.

Fig. 1

Metal Frame

Clip

Outer Glass Shade

Inner Glass Shade

Loop

Nipple

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Turn off the power at fuse or circuit box.

Installation Steps

Summary of content (2 pages)

PAGE 1
T0139 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Pull out the source wires from the post. Make wire connections using wire nuts as follow: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the post ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the post ---Attach the fixture grounding wire (usually green insulation or bare wire) to the grounding wire from the post. Carefully put the wires back into the post. 6.