Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0149
Finial
Tube
141227
Wire Nut (B)
Metal Frame
Clip
Post Grounding Wire
Fixture Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter
Fitter Screw (A)
Bulb Type B Max.60W
(not included)
Fitter Screw (A)
Photocell
Candle Tube
Socket
Fixture
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
Hex Nut
Rubber Pad
Top Cover
Bottom Cover
Dome
1. Place the glass shade into the metal frame carefully, and then secure
it by pressing the clips from the top side. (See Figure 1)
2. Screw the tube to the fixture.
3. Pull out the source wires from the post. Make wire connections using
wire nuts as follow:
---Connect the hot wire (usually black insulation) from the fixture to the
black wire from the post
---Connect the neutral wire (usually white insulation) from the fixture to
the white wire from the post
---Attach the fixture grounding wire (usually green insulation or bare
wire) to the grounding wire from the post.
Carefully put the wires back into the post.
Fig. 1
Glass Shade
Hardware Package (included):
Turn off the power at fuse or circuit box.
Installation Steps
Glass Shade
Clip
Metal Frame
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.