Installation Guide

Page 1 / 3

170413

Important to Know:

1. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified

electrician.

2. This fixture requires a 120 VAC, 60 Hz power source.

3. For general safety, be sure the power is switched "off" before adjustment.

4. Switch control LED flood light.

Note:Only general ON/OFF wall switch applies for this fixture, the dimmable wall switch shouldn’t be

required.

Maximum Wattage: 28 W

Working Temperature Range: -4ºF ~ 113ºF

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0329 / T0330

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Note: Fixture can be wall mounted or eave mounted.

Light fixture and light head should be mounted as shown above when installed (depending upon type of installation).

Hardware Package (included):

Mounting Screw X2

#8/32X1/2 in

Fixture Mounting Screw

Mounting Strap

Wire Connector X3

Mounting Screw X2

#6/32 X1/2 in

Mounting Screw X2

#10/24 X1/4 in

Decorative cover Gasket

Mounting Strap

Outlet Box

Mounting Screw

Back Plate

Fixture Mounting Screw

Decorative Cover

Gasket

Wire

Connector

FRONT

Wall Mounted

Eave Mounted

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0329 / T0330 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box. 1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using two mounting screws that best fit the outlet box. (Choose one matching pair of suitable mounting screws from the 3 pairs provided) 2. Thread the fixture wires through gasket, and then attach the gasket into back plate of the light fixture. 3. Pull out the source wires from the outlet box.
PAGE 3
Troubleshooting ---The light does not come on at all: 1. Make sure the wall switch and circuit breaker are on. 2. Make sure the wiring is correct. ---The light flashes on and off: 1. Use a standard on/off wall switch to control the light fixture, instead of a dimmer and timer. The following parts are available for re-order if damaged or missing.