Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0341
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
170822
Turn off the power at fuse or circuit box.
Installation Steps
Turn on the power at fuse or circuit box.
Wire Connector (B)
Fitter Screw (A)
Hardware Package (included):
Grounding Wire
Fixture Wire
Wire Connector (B)
Post
Glass Shade
Fixture
Bulb T10 5” high
or Type B Max.60W
(not included)
Holder
Ball nut
Fitter
Fitter Screw(A)
Socket
2. Install a bulb (not included). Check relamping
1. Unthread two Ball nuts from the fixture.
label at socket area or packaging for maximum
allowed wattage.
3. Tighten the glass shade into the Socket and then attach
the assembly to the fixture using two Ball nuts.
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
4. Pull out the source wires from the post. Make wire connections
using wire connectors as follow:
---Connect the hot wire (usually black insulation) from the fixture to
the black wire from the post
---Connect the neutral wire (usually white insulation) from the
fixture to the white wire from the post
---Attach the fixture grounding wire (usually green insulation or
bare wire) to the grounding wire from the post.
Carefully put the wires back into the post.
5. Place the fitter on the post, then secure it with the fitter screws.

Summary of content (2 pages)