Installation Guide

ManualsBrandsCascadia ManualsOutdoor Flush Mount LightsBruges 12-in W Parisian Bronze Outdoor Flush Mount Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0342

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

170822

Turn on the power at fuse or circuit box

Turn off the power at fuse or circuit box.

Installation Steps

Hardware Package (included):

Mounting Screw (B)

Threaded Pipe (E)

Green Grounding

Screw (C)

Wire Connector (D)

Mounting Strap (A)

Hex Nut (F)

Washer(G)

End Cap(H)

1. Attach the threaded pipe to the mounting strap,

and then secure it with a washer and a hex nut.

2. Attach mounting strap to the outlet box using

two mounting screws.

3. Unthread the four set screws from ceiling pan.

4. Pull out the wires and grounding wire from the outlet

box. Make wire connections using the wire connectors

as follows:

---Connect the hot wire (usually black insulation)

from the fixture to the black wire from the power

source.

---Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power

source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green

grounding screw, and then connect it to the house grounding wire with the wire connector.

Carefully put the wires back into the outlet box.

5. Attach the ceiling pan to the mounting strap by inserting threaded pipe into the center holes of the ceiling pan and

screw the end cap to secure ceiling pan.

NOTE:Depth of threaded pipe may need to be adjusted to properly fit end cap.

6. Install bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.

7. Attach the glass and fixture up to the ceiling pan by aligning four holes, and then secure it with four set screws.

End Cap(H)

Ceiling Pan

Set Screw

Bulb T10 5” high

or Type B Max.60W

(not included)

Socket

Fixture

Glass Shade

Mounting Screw (B)

Green Grounding Screw (C)

Wire Connector(D)

House Grounding Wire

Fixture Grounding Wire

Outlet Box

Fixture Wire

Threaded Pipe(E)

Mounting Strap (A)

Hex Nut (F)

Washer (G)