Installation Guide

ManualsBrandsCascadia ManualsSecurity Motion Detectors240-Degree Bronze LED Motion-Activated Flood Light with Dusk to Dawn and Timer

Page 3 / 5

150105

OFF

Sensitivity

Test

3MIN

TIME

Fig. 4

Fig. 5

“ON” or “OFF”

Mode

Manual

Override

Manual Override Operation Diagram

Turn wall switch OFF-ON

-OFF-ON in 0.5~3

Seconds

Turn wall switch OFF-ON

-OFF-ON in 0.5~3 Seconds

Fig. 6

Sensitivity of Motion Sensor

● You can adjust the sensitivity of the motion sensor by using the “SENSITIVITY” selector located on the right side

of the bottom surface of the sensor. (See Fig. 4)

● Adjust motion sensor sensitivity to achieve desired performance.

● Approximate range for each setting from 10ft to 75ft.

Adjusting the Light Head:

1. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the light

heads at least 1” (25mm) away from the sensor.(See Fig. 5)

2. Keep the light heads 30˚ below horizontal to avoid water damage and electrical shock.

Light Head

Function and Operation

Note: When power is first applied, the light will turn on to 100% brightness. The sensor will take 30+/-10 seconds

to warm up.

1. Test mode

1. Slide the slide switch to the “TEST” position on the bottom of the sensor head.

2. Turn on the circuit breaker and light switch. Allow the fixture to warm up approximately 40 seconds before testing.

(Lights may come on during warm-up period.) Then the light will turn to low-level brightness (400 lumen)

automatically.

3. The light will turn to high-level brightness when motion is detected, and stays on as long as the motion is continuing.

It will then revert to low-level brightness (400 lumen) about 5 seconds after motion is no longer detected.

2. Manual mode(nighttime operation only)

1. Place the slide switch in the ON position. At dusk, the light will turn to low-level brightness (400 lumen). The light will

turn to high-level brightness when motion is detected, and stay on as long as the motion is continuing. When the

motion stops, the light will remain on for the predetermined time set (5 ~ 180 seconds), and then revert to low-level

brightness.

2. Place the slide switch in the OFF position. At dusk, the light will turn to high-level brightness automatically when motion

is detected, and stays on as long as the motion is continuing. When the motion stops, the lights will remain on for the

predetermined time set (5 ~ 180 seconds), then the light will turn off automatically.

3. Manual Override mode (nighttime operation only)

1. To shift to the manual override mode, set the slide switch

to “ON” or “OFF” mode. Turn the wall switch “OFF” and turn

it “ON” twice within 3 seconds. The light will remain on all

night long. To shift back to the “ON” or “OFF” mode, turn the

wall switch “OFF”, and turn it “ON” twice within 3 seconds

again. (See Fig.6)

2. The light will turn off automatically at dawn.

Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position (including

the daytime).