Installation Guide

Page 2 / 17

Installation Steps

Turn off the power at fuse or circuit box.

Turn on the power at fuse or circuit box.

Mounting Strap

Outlet Box

Wire Connector

Back Plate

Mounting Screw

Light Head

Fixture Mounting Screw

FRONT

Decorative cover

Sensor Head

1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using

two mounting screws that best fit the outlet box. Back plate should sit flush against wall surface when secured.

(Choose one matching pair of suitable mounting screws from the 3 pairs provided)

2. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:

---Connect the black wire from the fixture to the “hot” wire from the power source. (usually black)

---Connect the white wire from the fixture to the neutral wire from the power source. (usually white)

Carefully tuck the wires back into the outlet box.

3. Attach the back plate of the light to the mounting strap, secure it with the fixture mounting screw.

4. Push the decorative cover firmly into the fixture mounting screw hole on the light.

5. With silicone caulking compound, caulk completely around where the back plate meets the wall surface.

CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from

seeping into the outlet box.

Adjusting the Sensor Head:

1. Aim sensor head toward desired detection area, maintaining a 5° - 40°

downward angle to allow moisture to drain.

Note: Make sure sensor head is positioned with controls facing toward

the ground.

2. You can rotate the sensor head up and down to change the coverage area .

Walk through the detection zone at the farthest distance you wish to detect motion.

(See Fig. 1)

Note: Range set too high may increase false triggering. (See Fig. 2 and Fig. 3 )

Sensor Adjustment Lower For Short Coverage

Sensor Adjustment Higher For Long Coverage

Fig. 2

Fig. 3

Fig. 1

171019