Installation Guide

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0414 / T0415

180408

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Mounting Screw X2

#8/32X1/2 in

Mounting Screw X2

#6/32 X1/2 in

Decorative cover

Fixture Mounting Screw

Mounting StrapMounting Screw X2

#10/24 X1/4 in

Wire Connector X3

Page 1 / 3

Wall Mounted

Eave Mounted

Note: Fixture can be wall mounted or eave mounted.

Important to Know:

1. If you are not familiar with state and local electrical

codes, it is recommended that you consult with a

qualified electrician.

2. This fixture requires a 120 VAC, 60 Hz power

source.

3. For general safety and to avoid any possible

damage to the photocell, be sure the power is

switched "off" before adjustment.

Maximum Wattage: 44 W

Working Temperature Range: - 4°F ~ 113°F

Features:

1. Energy saving LED fixture.

2. Photocell keeps the light OFF during daylight hours.

3. When in manual override mode, it can be switched

from 100％ high level to low level brightness.

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0414 / T0415 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Light fixture should be mounted as shown above when installed (depending upon type of installation) Back Plate Wire Connector Outlet Box FRONT Light Head Decorative cover Fixture Mounting Screw Photocell Mounting Strap Mounting Screw IMPORTANT: The fixture features a photocell sensor which enables the light to turn on at dusk and off at dawn automatically. Fig.
PAGE 3
6. Gently grasp the light heads and move them up or down, left or right to adjust the light coverage area. Keep the light heads 30˚ below horizontal to avoid water damage and electrical shock (See Fig 2) . Fig. 2 Turn on the power at the main fuse or circuit breaker box. Note: When power is first applied, the light will turn on immediately. Wait for 15 seconds to allow the sensor to warm up. Troubleshooting ---The light does not come on at all: 1. Make sure the wall switch and circuit breaker are on. 2.