Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
.stnemeriuqer gnidnuorg dna gniriw rof sedoc lacirtcele lacol tlusnoc ,gnillatsni erofeB .1 :SETON
2. READ AND SAVE THESE INSTRUCTIONS.
T0465
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Installation Steps
201103
1. Pull out the wires and grounding wire from
the post. Make wire connections using the
wire connectors (B):
---The black wire from the fixture to the black
wire from the post.
---The white wire from the fixture to the white
wire from the post.
---The grounding wire from the fixture to the
grounding wire from the post.
Carefully put the wires back into the post.
2. Place the fitter on the post, then secure it with the
fitter screws (A).
CAUTION: With silicone caulking compound,
caulk completely around where the fitter meets
with the post surface to prevent water from seeping
into the post.
3. Place the candle tubes over the sockets, then secure the rod into the coupling.
4. Install three bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
5. Slide the dome and the lower cap down through the rod, secure them with a hex nut. Then slide the upper cap
down through the rod, and secure it with a rubber pad and loop.
Wire Connector (B)
Fitter Screw (A)
Grounding Wire
Fixture Wire
Wire Connector (B)
Post
Fitter Screw (A)
Glass Frame
Coupling
Socket
Socket Base
Fitter
Candle Tube
Loop
Rubber Pad
Hex Nut
Upper Cap
Lower Cap
Rod
Dome
Bulb Type B Max.60W
(not included)