Installation Guide

ManualsBrandsCascadia ManualsWall LampsChapeau Plug-in Brass Cone Motion Sensor Swing Arm Wall Lamp White Linen Shade

Back Plate

Mounting Screw (B)

Green Grounding

Screw (E)

Wire Connector (F)

170908

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0200 / W0201 / W0261

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Lock Nut

(D)

Headless Screw (C)

Ball Nut (G)

1. Thread two headless screws through the cross bar, then secure them with four lock nuts (two on each side of the

cross bar). Adjust the length of the headless screws if necessary.

Note: Make sure that the headless screws are lined up horizontally to make the fixture level.

2. Attach the cross bar to the outlet box by using two mounting screws.

Socket Ring

Shade

Bulb Type A Max.60W

(not included)

Socket

Holder

Turn off the power at fuse or circuit box.

Ball Nut (G)

This FIXTURE can be mounted in two ways.

Option 1: (Hard Wire Installation)

Assembly Instructions:

Strain Relief (H)

Pipe Strap (N)

Dry Wall Screw (O)

Bushing (P)

Anchor (L)

Hex Nut (J)

Washer (K)

Threaded Pipe (M)

Outlet Box

Wire Connector (F)

Green Grounding Screw (E)

Headless Screw (C)

Cross Bar(A)

Mounting Screw (B)

Lock Nut(D)

Fixture Grounding Wire

House Grounding Wire

Fixture Wire

Swivel (I)

Rocker Arm

Cross Bar(A)

Summary of content (4 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0200 / W0201 / W0261 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows: ---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source. ---Attach the fixture grounding wire (usually bare wire) to the cross bar with the green grounding screw, then connect it to the house grounding wire with a wire connector.
PAGE 3
8. Cut any excess plug cord leaving 10 inches from the back plate. Slit the plug cord apart in 5 inches. Peel off insulation of the two wires in 5/8 inch. (See Fig.2) Fig.2 9. Pull out the source wires from the back plate. Make wire connections using wire connectors as follows: ---The black wire from the back plate to the smooth wire (marked) from the plug cord. ---The white wire from the back plate to the ridged wire (unmarked) from the plug cord. Carefully put the wires back into the back plate.
PAGE 4
The following parts are available for re-order if damaged or missing.