Installation Guide

Power Cable

Die Cast Connector

Dry Wall Screw

Plastic Plug

Power Supply Box

Dry Wall Screw

Power Cable

Link Cord

Outlet

160127

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Hardware Package:

X0063 / X0064

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

1. Remove the plastic plug from power supply box.

(See Fig.1)

2. Find a suitable location to mount the power

supply box. The mounting surface should be a

minimum of 1/2” thick.

3. Place the power supply box to the mounting

surface and then secure it to cabinet with two dry

wall screws. (Do not over tighten screws).

(See Fig. 1)

4. Plug the connector of link cord into the power

supply box (the link cord connects light fixture.)

Plug the connector of the power cable into power

supply box. Place the wall plug into a 120VAC

60HZ outlet. (See Fig.2)

Fig.1

Fig.2

This FIXTURE can be mounted in two ways.

. Installing the fixture with power cable:

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS X0063 / X0064 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package: Dry Wall Screw Power Cable Die Cast Connector This FIXTURE can be mounted in two ways. A. Installing the fixture with power cable: 1. Remove the plastic plug from power supply box.
PAGE 2
B. Direct Wire Installation: Fig.3 Turn off the power at fuse or circuit box 1. Remove all plastic plugs from power supply box. (See Fig.1) 2. Find a suitable location to mount the fixture. The mounting surface should be a minimum of 1/2” thickness. 3. Once you have determined the position where the light fixture will be mounted, mark the corresponding knockout closest to your supply wire feed. CAREFULLY REMOVE THE KNOCKOUT BY HAMMERING A FLATHEAD SCREWDRIVER OR PUNCH UNTIL THE SURFACE BREAKS.