Specifications

Remote-Control CommandsGPS and Assisted GPS
97Operating Manual 1171.5248.12 ─ 15
Parameters:
<Rcode> CACode | CAPCode | PCODe
CACode
Carrier L1 (f_L1= 1.57542 GHz) is modulated by C/A-code
(BPSK).
CAPCode
(only available for Satellite 1)
Carrier L1 (f_L1= 1.57542 GHz) is modulated by C/A code and P-
code (QPSK).
PCODe
(only available for Satellite 1)
Carrier L1 (f_L1= 1.57542 GHz) is modulated by P-code (BPSK).
*RST:
CACode
Example:
BB:GPS:SMOD GEN
generic satellite signals are generated.
BB:GPS:SAT1:RCOD CAC
sets the C/A ranging code for satellite 1.
[:SOURce<hw>]:BB:GPS:SATellite<st>:STATe <State>
Enables/disables generation of the signal of the selected satellite.
Suffix:
<st>
.
1 .. 4
Parameters:
<State> 0 | 1 | OFF | ON
*RST: SAT1: ON ; SAT<2|3|4>: OFF
Example:
BB:GPS:SAT1:STAT ON
enables generation of the signal of satellite 1.
[:SOURce<hw>]:BB:GPS:SATellite<st>:SVID <Svid>
Sets the ID of the satellite to be simulated. This value is used to generate the corre-
sponding C/A code.
If "Real Navigation Data" is used, only the valid IDs which are listed in the almanac can
be selected.
For arbitrary data, any IDs can be selected.
Suffix:
<st>
.
1 .. 4
Parameters:
<Svid> float
Range: 1 to 37
*RST: SAT1: 1 / SAT2: 2 / SAT3: 3 / SAT4: 4
Satellites Configuration and Satellites Signal Settings