Specifications

Remote-Control CommandsGPS and Assisted GPS
142Operating Manual 1171.5248.12 ─ 15
Return values:
<Frequency> float
Example:
BB:GPS:TRIG:OUTP2:PULS:DIV 2
sets the divider for the marker signal on output MARKER 2 to the
value 2.
BB:GPS:TRIG:OUTP2:MODE PULS
enables the pulsed marker signal.
BB:GPS:TRIG:OUTP2:PULS:FREQ?
queries the pulse frequency of the marker signal.
Response: 511511.038
the resulting pulse frequency is 511.511 kHz.
Usage: Query only
[:
SOURce<hw>]:BB:GPS:TRIGger:OUTPut<ch>:PULSe:WIDTh <Width>
Sets the Pulse Width for 1PPS and 1PP2S marker mode
(SOUR:BB:GPS:TRIG:OUTP:MODE PPS | PP2S).
Parameters:
<Width> float
Range: 1 to 800
Increment: 1
*RST: 1
Example:
BB:GPS:TRIG:OUTP2:MODE PPS
enables the 1PPS marker signal.
BB:GPS:TRIG:OUTP1:PULS:WIDT 2
sets the pulse width for the marker signal on output MARKER 2 to
the value 2.
4.8 Clock Settings
This section lists the remote control commands, necessary to configure the clock.
The clock settings are available for R&S SMx and R&S AMU instruments only.
[:SOURce<hw>]:BB:GPS:CLOCk:MODE..........................................................................142
[:SOURce<hw>]:BB:GPS:CLOCk:MULTiplier....................................................................143
[:SOURce<hw>]:BB:GPS:CLOCk:SOURce.......................................................................143
[:SOURce<hw>]:BB:GPS:CLOCk:MODE <Mode>
Enters the type of externally supplied clock (:BB:GPS:CLOCk:SOURce EXTernal).
Clock Settings