Installation Guide

ManualsBrandsCash Acme ManualsPressure Relief Valves & Regulators22267-0045

Adjustment

Knob

Pressure

Indicator

Pressure

Reducer

Cartridge

Direction

Arrow

A division of the Reliance Worldwide Corporation

Installation:

Thoroughly flush out the system before

installing valve. It is recommended that isolat-

ing valves be installed both upstream and

downstream to ease in servicing the valve. Install in an

accessible location and orient the valve to correspond

with the direction of flow (indicated by arrow on the Valve

Body)(Fig. 1). Avoid stressing the valve by ensuring that

inlet and outlet pipework are properly supported and

aligned.

Viewing Pressure

Indicator:

If necessary, the

Pressure Reducer

Cartridge can be

rotated to best view the

Pressure Indicator. The

outlet pressure is factory

preset to the value

indicated by the

Pressure Indicator. The

Pressure Indicator will

display approximate

outlet pressure. (Fig. 2)

IMPORTANT!

Do not turn

pressure indicator to

adjust outlet pressure

Fig. 1

Pressure Adjustment:

To adjust outlet pressure,

pull the ORANGE

Adjustment Knob upward

(Fig.3) then turn counter

clockwise (-) to decrease

pressure or clockwise (+) to

increase pressure. (Fig. 4)

Snap the knob back down

to lock its position after

adjusting. (Fig.5)

1 2

SoloSet

2400 7th Ave. SW,

Cullman, Al 35055

www.cashacme.com

1-877-700-4242

Fig. 2

Fig. 3

Fig. 4

Please turn over for

additional instructions.

Fig. 5

For Water Service, with Bronze or Stainless Steel Body and Inbuilt Back-Pass-Check

Type EB25, EB25-SS & EB25-400

PRESSURE REDUCING VALVE

Summary of content (2 pages)

PAGE 1
Installation: Thoroughly flush out the system before installing valve. It is recommended that isolating valves be installed both upstream and downstream to ease in servicing the valve. Install in an accessible location and orient the valve to correspond with the direction of flow (indicated by arrow on the Valve Body)(Fig. 1). Avoid stressing the valve by ensuring that inlet and outlet pipework are properly supported and aligned.
PAGE 2
4 Maintenance: Close isolating valves upstream and downstream before attempting to service the valve. Unscrew the Cartridge Nut. (Fig. 6 and Fig. 7) Fig. 6 Fig. 7 Remove the Pressure Reducer Cartridge by pulling straight up. (Fig. 8) Clean with cold water only. Replace the Strainer Screen before re-installing the Pressure Reducer Cartridge. (Fig. 9) Orient the Pressure Reducer Cartridge to best view indicator. Fig.