SharkBite ® PEX-A Installation Guide for Expansion Fittings Crimp Fittings Clamp Fittings EvoPEX Fittings SharkBite Brass Push
Table of Contents The SharkBite PEX-A Connection System Introduction ® SharkBite® Introduction 2 Features & Benefits 2 Expansion Fittings The purpose of this guide is to familiarize plumbing professionals with the SharkBite PEX-A pipe and expansion fitting connection system and the recommended method of installation. SharkBite PEX-A pipe and expansion fittings are an excellent system for plumbing jobs, offering many more advantages than rigid pipe.
Making a SharkBite Expansion Connection Making a SharkBite Crimp/Barb Connection Only expansion fittings listed to ASTM F1960 are approved for use on PEX-A pipe. Crimp/barb fittings listed to ASTM F1807 approved for PEX-A, PEX-B and PEX-C pipe. ® Step 1 Step 1 Use pipe cutters to make a square cut of the pipe to length. A rough or uneven cut can result in a weakened joint. Use pipe cutters to make a square cut of the pipe to length. A rough or uneven cut can result in a weakened joint.
Making a SharkBite Clamp/Barb Connection Making a SharkBite EvoPEX Connection Clamp/barb fittings listed to ASTM F2159 approved for PEX-A, PEX-B and PEX-C pipe. EvoPEX fittings listed to ASSE 1061 approved for PEX-A, PEX-B and PEX-C pipe. ® ® Step 1 Step 1 Use pipe cutters to make a square cut of the pipe to length. A rough or uneven cut can result in a weakened joint. Cut the desired length of pipe. y Make a square cut, perpendicular to length of tubing.
Making a SharkBite Connection SharkBite PEX-A Pipe Guidelines SharkBite push-to-connect fittings listed to ASSE 1061 approved for PEX-A, PEX-B and PEX-C pipe. For potable water and hydronic distribution. ® Making Connections (3/8 in. - 1 in.) Disconnections (3/8 in. - 1 in.) Cut the desired length of pipe. Remove fittings with disconnect clips. y Make a square cut, perpendicular to the length y Place disconnect clip against the end of the of the pipe. fitting.
Proper Support of SharkBite PEX-A Pipe Technical Data for SharkBite PEX-A SharkBite PEX must be properly supported to protect against excessive strain. For both vertical and horizontal applications we recommend the pipe be supported every 32 inches between supports, leaving a little slack (1/8-1/4 inch) in the pipe to allow for normal expansion and contraction. Always use approved PEX supports, and never use a support that has sharp edges. Certifications ® Typical approved PEX support.
For more information, visit sharkbite.com Connect with us Reliance Worldwide Corporation 2300 Defoor Hills Rd NW, Atlanta, GA 30318 Phone: 1-877-700-4242 • Fax: 1-877-700-4280 rwc.com Reliance Worldwide Corporation (Canada) Inc. 74 Alex Avenue Vaughan, Ontario, L4L 5X1 Phone: 1-888-820-0120 Sales Inquiries: canadasales@rwc.com Orders: canadaorders@rwc.com Certifications The most up-to-date certifications can be found at sharkbite.com. Manufactured & Distributed by Reliance Worldwide Corporation®.
