User's Guide

Introduction (Basic Operation)

IMPORTANT!

• If you press the [p] (Power) button when the AC adapter for camera charging is

connected to the camera, the camera starts up. At that point, charging stops.

• The AC adapter for camera charging heats up slightly during charging. This is

normal and does not indicate malfunction.

Operation check indicator operation

Other Important Notes on Charging

• The lithium-ion battery (DNP-100M) should only be charged using the methods

specified in this manual.

• If the battery has become hot after being used, it may not be fully charged. Allow

the battery to cool down and then recharge it.

• The battery will self-discharge even when it is not being used. Always charge the

battery before use.

• Charging may produce interference with a TV or radio. In this event, use a mains

power socket that is as far away as possible from the TV or radio.

• Charging times will vary somewhat depending on the battery capacity, its

remaining charge and the operating environment.

• For charging, use the device specified in this manual. The use of any other device

could make it impossible to correctly charge the battery.

• To cut off power to this camera, unplug the AC adapter from the mains power

socket.

• Do not place this camera in a location that interferes with connecting or

disconnecting the AC adapter.

• Do not operate this product with wet hands when using the AC adapter.

• In environments where this product is used with patients, charge it using the AC

adapter for camera charging.

Action Details

Lights orange Charging

Flashes red

Abnormal ambient temperature, AC

adapter fault or battery fault (page 74)

Off Charging completed

Operation check

indicator