User's Manual
E-26
Synchronizing the Watch with the Sensor Bar
Before you start exercising, make sure that the watch is receiving
the anti-interference code transmitted from the sensor bar, and
synchronize the watch with the sensor bar. See “Anti-interference
Code” on page E-27 for more information.
• If you don’t synchronize the watch with your sensor bar, your
watch may start picking up the signal transmitted from another
sensor bar.
• The sensor bar starts transmitting automatically as soon as you
put on the chest strap and the sensor pads start picking up your
heart beat.
While you are wearing the chest strap, press the C button while the
watch is in the Timekeeping Mode, Stopwatch Mode, or Timer Mode to
start synchronization.
After synchronization is complete, the watch will receive the signal from
the sensor bar and display your heart rate and exercise intensity.
• The heart symbol will flash on the display while your heart rate is
being monitored.
• Pressing the C button while the watch is monitoring your heart rate
will perform synchronization again.
• Synchronization will be cancelled automatically if the watch is not able
to receive any signal from the sensor bar for about 60 seconds.
Timekeeping Mode Stopwatch Mode
Heart symbol
Heart symbol