User's Manual

E-40
To configure timer settings
1. In the Timer Mode, check the display to
make sure the timer is stopped and
reset to all zeros.
• If the timer is running, press the B
button to stop it. To reset the timer to
all zeros, press the B button again.
2. Hold down the A button for about two
seconds until the number of repeats at
the top of the display starts to flash.
• This is the setting screen.
3. Configure the timer settings as shown
below.
• Use the D button to move to the next
setting. Use the E (+) and B (–)
buttons to change the currently
selected setting.
• Holding down the E or B button
changes the current setting at high
speed.
• For a starting time of 100 hours, set 0
hours 00 minutes 00 seconds.
4. After all the settings are the way you
want, press the A button to exit the
setting screen.
• The watch also will exit the setting
screen automatically if you do not
perform any operation for about two or
three minutes.
(2 seconds)