User's Manual
E-48
To set an alarm time
1. In the Alarm Mode, display the screen of
the alarm whose setting you want to
change.
2. Hold down the A button for about two
seconds until the hour digits of the
current alarm time start to flash. This is
the setting screen.
• Displaying the setting screen also
turns on the alarm automatically and
causes the alarm on indicator to
appear on the screen.
3. Use the E (+) and B (–) buttons to change the hour setting.
• Holding down either button changes the setting at high speed.
• When setting the hour, make sure you specify AM or PM (P)
correctly when using 12-hour timekeeping, or that you specify the
correct 24-hour time. The same 12-hour/24-hour format you select
for the Timekeeping Mode time (page E-50) is also applied in the
Alarm Mode.
• The timekeeping system (12-hour or 24-hour) used in the Alarm
Mode is the same one you select for the Timekeeping Mode (page
E-50).
4. Press the D button to move the flashing to the minutes.
5. Use the E (+) and B (–) buttons to change the minute setting within
the range of 0 to 59.
• Holding down either button changes the setting at high speed.
6. After all the settings are the way you want, press the A button to exit
the setting screen.
• The watch also will exit the setting screen automatically if you do
not perform any operation for about two or three minutes.
(2 seconds)