User manual

1683-3
Alarm 1
Alarm 4
Alarm 5
Alarm 2 Alarm 3
Hourly Time Signal
2. After you select an alarm, hold down
AA
until the hour digits start to flash on the
display. The hour digits flash because they are selected. At this time the Alarm is
automatically switched on.
3. Press
CC
to change the selection in the following sequence.
4. Press
EE
to increase the number or
BB
to decrease it. Holding down either button
changes the current number at high speed.
· The format (12-hour and 24-hour) of the alarm time matches the format you select
for normal timekeeping.
· When setting the alarm time using the 12-hour format, take care to set the time
correctly as morning or afternoon.
5. After you set the alarm time, press
AA
to return to the Alarm Mode.
· If you do not operate any button for a few minutes while a selection is flashing, the
flashing stops and the watch goes back to the Alarm Mode automatically.
To stop the alarm
· Press any button to stop the alarm after it starts to sound.
To switch an alarm and Hourly Time Signal on and off
1. In the Alarm Mode, press
EE
to select an alarm or the Hourly Time Signal.
2. When the alarm or Hourly Time Signal you want to is selected, press
BB
to switch it
on and off.
· If any alarm is on, the Alarm On indicator is shown on the display when you change
to another mode.
To test the alarm
Hold down
EE
while in the Alarm Mode to sound the alarm.
Hour DayMinutes
Month
Alarm on indicator Hourly time signal on indicator
ALARM MODE
You can set five independent alarms with the hour,
minutes, month and day. Use the Alarm Mode to turn the
alarm and the Hourly Time Signal on and off.
· When an alarm is turned on, an alarm tone sounds for
20 seconds when the preset time reached.
· When the Hourly Time Signal is turned on, the watch
beeps every hour on the hour.
Alarm types
The types of alarm you get depends on the information
you set.
· To set a daily alarm
Set the hour and minutes for the alarm time. Set “-” for
the month and “--” for the day. This type of setting
causes the alarm to sound everyday at the time you set.
·
To set a date alarm
Set the month, day, hour and minutes for the alarm time. This type of setting causes
the alarm to sound at the specific time, on the specific date you set.
·
To set a 1-month alarm
Set the month, hour and minutes for the alarm time. Set “--” for the day. This type of
setting causes the alarm to sound every day at the time you set, only during the
month you set.
·
To set a monthly alarm
Set the day, hour and minutes for the alarm time. Set “-” for the month. This type of
setting causes the alarm to sound every month at the time you set, on the day you
set.
To set the alarm time
1. Press
EE
while in the Alarm Mode to select Alarm 1 through Alarm 5.
Mode indicator
Alarm on
indicator
Hours Minutes
Hourly time signal
on indicator