User manual

●
Swapping Your World Time and Home
Time
1.
Y Tap the “CASIO WATCH+” icon.
2.
X
Hold down the (B) button for about 1.5
seconds.
●
The
second
hand will move to “R”. Keep
(B) depressed until the second hand
starts moving again and then stop at
“R”.
●
The second
hand will move to e when a
connection is established between the
watch and phone.
3.
Y Tap z.
4.
Perform the operation shown on the
phone screen to swap your Home Time
with your World Time.
For example, if your Home City is Tokyo
and the
World Time City is New York, they
will be swapped as shown below.
30
30
World Time City
(New York)
World Time City
(Tokyo)
Home City
(New York)
Home City
(Tokyo)
After swappingBefore swapping
Note
●
Auto time adjustment is not
performed for 24 hours after
swapping of the Home Time and
World Time.
Correcting Hand Alignment
If the hands are out of alignment even though
auto time
adjustment is being performed, use
CASIO WATCH+ to adjust them.
1.
Y Tap the “CASIO WATCH+” icon.
2.
X
Hold down the (B) button for about 1.5
seconds.
●
The second
hand will move to “R”. Keep
(B) depressed until the second hand
starts moving again and then stop at
“R”.
●
The second
hand will move to e when a
connection is established between the
watch and phone.
3.
Y Tap in the following sequence: f n
“Watch settings”.
4.
Y Tap “Adjusting home positions
”.
5.
Y Perform the operation shown on the
phone screen.
Phone Finder
You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in the
manner mode.
Important!
●
Do not use this function in areas
where phone call tones are
restricted.
●
The tone sounds at a high volume.
Do not use this function when
listening to phone output over
earphones.
1.
X If the watch is connected with a phone,
press (B) to terminate the connection.
30
30
After disconnectionConnected
2.
X Hold down (C) for about 0.5 seconds
until the second hand points to “R”.
The second hand will move to e
when a
connection is established between the
watch and phone, and then the phone’s
ringtone will sound.
●
It will take a few seconds before the
phone tone sounds.
3.
X Press any button to stop the tone.
●
You can press any watch button to stop
the phone tone only during the first 30
seconds after it starts to sound.
Configuring Watch Settings
You can use CASIO WATCH+ to specify the
amount of
time until the Bluetooth connection
is automatically terminated, and to configure
other settings.
1.
Y Tap the “CASIO WATCH+” icon.
2.
X Hold down the (B) button for about 1.5
seconds.
●
The
second
hand will move to “R”. Keep
(B) depressed until the second hand
starts moving again and then stop at
“R”.
●
The second
hand will move to e when a
connection is established between the
watch and phone.
3.
Y Tap in the following sequence: f n
“Watch settings”.
4.
Y Select the setting you want to change
and then perform the operation shown on
the phone screen.
Operation Guide 5466
7