User Manual

20010101
4-5-4
Starting a Sampling Operation
# Conductivity, heart rate, and pH sensors
Sample values produced by these types of
sensors lose accuracy unless the sensors are
allowed to warm up. Perform the following
procedure to ensure better sampling accuracy.
Using a Heart Rate Sensor
1. Select [TRIGGER] as the Trigger Source
item of Advanced Setup’s Trigger
parameter.
2. When the EA-100 is in the Ready state
prior to sampling, hold down the EA-100’s
[TRIGGER] key for about 20 to 30
seconds, and then release it.
3. Press the EA-100’s [TRIGGER] key when
you want to start sampling.
Using a Conductivity or pH Sensor
1. Select [Yes] for the [Real-Time] setting on the
Sample Setup screen of the Advanced Setup
menu.
#Initial samples using conductivity, heart rate,
and pH sensors are always inaccurate when
starting from Setup Wizard.
# For detailed information about a sensor, see
the documentation that comes with it.
20011101