User Manual

Power Outlet
EN-7
English
1. Press the 3SETTING button to display the
setting screen.
2. Use the clw and q arrow buttons to
select “General” and then press the
cmENTER button.
3. Use the clw and q arrow buttons to
select “LCD Contrast”.
4. Use the clu(–) and i(+) arrow buttons to
adjust display contrast.
• The contrast setting range is 0 to 26.
5. Press the 3SETTING button to exit the
setting screen.
Perform the following procedure when you want to
return the Digital Piano’s stored data and settings to
their initial factory defaults.
1. Press the 3SETTING button to display the
setting screen.
2. Use the clw and q arrow buttons to
select “General” and then press the
cmENTER button.
3. Use the clw and q arrow buttons to
select “Factory Reset” and then press the
cmENTER button.
• This causes the confirmation message “Initialize
All?” to appear.
4. Press the cmENTER button.
• This will cause the confirmation message “Sure?” to
appear.
5. Press the cli arrow button to execute the
initialize operation.
• To cancel the initialize operation, press the clu
arrow button.
• The message “Please Wait...” will remain on the
display while the operation is being performed. Do
not perform any operation while this message is on
the display. “Complete!” appears on the display after
the operation is complete.
Enable this setting when you want to protect against
unintentional button operations.
It locks most of the Digital Piano’s buttons, so their
operations are disabled.
Only operation of the 1P (Power) and
4OPERATION LOCK buttons remain enabled.
1. Hold down the 4OPERATION LOCK button
until its lamp lights.
2. To unlock operations, press the
4OPERATION LOCK button again.
• This will cause the lamp above the button to go out.
Adjusting Display Contrast
Returning the Digital Piano to
Its Factory Default Settings
Operation Lock
AP700-ES-1B.indd 9 2015/04/06 12:22:56