User's Manual

53
Important!
The above procedure will not establish a wireless LAN connection if the connection
profile of the Data Projector is different from the profile used the first time a connection
was established between the computer and Data Projector (Simple Connection 1 in this
example). In this case, press the Data Projector’s remote controller [] key to display
the “Connection Profile” menu and then select the original connection profile (Simple
Connection 1 for this example). For details, see “To switch the Data Projector
connection profile” (page 66).
Establishing a Wireless LAN Connection with Multiple
Computers Using a Manual Connection
This section explains how to connect up to four computers to a single Data Projector (over
a wireless LAN access point) at the same time. The following are the general steps that
are required.
1 Prepare for wireless LAN connection of the Data Projector and the computers (below).
2 Create connection profiles for the computers (page 54).
3 Use the Manual Connection profile to establish a wireless LAN connection between the
first computer and the Data Projector (page 56).
4 Use the Manual Connection profile to establish a wireless LAN connection between the
other computers and the Data Projector (page 60).
1
11
1To prepare for wireless LAN connection of the Data Projector and the
computers
1
Install Wireless Connection on all of the computers.
2
Connect YW-2 wireless adapters to the USB port of each of the computers.