User`s guide

CHAPTER 3: CASIO BE-300 SETUP | 19
STEP 3: Install the Software
Follow these steps for software installation BEFORE inserting the ISC:
1. Download the software for the BE-300 onto a host PC. The software is
available at: www.socketcom.com/support/support_bar.htm
DO NOT install the software from the installation CD onto a BE-300!
2. Use the USB/serial cable or cradle that came with the BE-300 to
connect the BE-300 to a host computer. Perform a PC Connect. If you
need help with PC Connect, refer to the BE-300 user documentation.
3. Run the SETUP.EXE that you downloaded.
4. The CASSIOPEIA Application Installer will begin. Follow the
instructions on your host PC screen until installation is complete.
Note: You can choose to install the software either directly to the Main
memory of your BE-300 or to a removable memory card.
5. When installation is finished, disconnect the BE-300 from the host PC.
6. Soft reset the BE-300. Push the reset button, located on the left side of
the BE-300. Now you are ready to insert the card.
Important! Soft reset the BE-300 after software installation!
Push the reset button, located on the left side of the unit!