User`s guide

APPENDIX D: DEFAULT PARAMETERS | 37
Appendix D Default Parameters
Check the table below to identify default parameters for the ISC. To
program different settings, please use the Symbology Selector feature in
SocketScan or the parameter number and refer to the Symbol 923
Programming Guide Chapter 5 for In-Hand Scan in Adobe Acrobat PDF
format at: www.socketcom.com/support/support_bar.htm
Parameter Parameter # Default
Set Default Parameter All Defaults
Beeper Tone 0x91 Medium Frequency
Laser On Time 0x88 3.0 sec
Aim Duration 0xED 0.0 sec
Power Mode 0x80 Low Power
Trigger Mode 0x8A Level
Time-out Between Same Symbol 0x89 1.0 sec
Beep After Good Decode 0x38 Enable
Transmit "No Read" Message 0x5E Disable
Parameter Scanning 0xEC Enable
Linear Code Type Security Levels 0x4E 1
Bi-directional Redundancy 0x43 Disable
UPC/EAN Parameter # Default
UPC-A 0x01 Enable
UPC-E 0x02 Enable
UPC-E1 0x0C Disable
EAN-8 0x04 Enable
EAN-13 0x03 Enable
Bookland EAN 0x53 Disable
Decode UPC/EAN Supplementals 0x10 Ignore
Decode UPC/EAN Supplemental
Redundancy 0x50 7
Transmit UPC-A Check Digit 0x28 Enable
Transmit UPC-E Check Digit 0x29 Enable
Transmit UPC-E1 Check Digit 0x2A Enable
UPC-A Preamble 0x22 System Character
UPC-E Preamble 0x23 System Character
UPC-E1 Preamble 0x24 System Character