User Manual
EN-15
Digital Piano Operation
■ To change the reverb and chorus settings of a
recorded performance
1.
Perform one of the operations below to select
the reverb or chorus effect you want to apply to
the recorded performance.
“To add reverb to notes” (page EN-10)
“To add the chorus effect to notes” (page EN-10)
2.
While holding down the 3 FUNCTION button,
perform steps (1) and (2) below.
(1) Press the RECORDER SETTING (D6) keyboard key.
• This causes a short beep to sound.
• Note that performing step (2) below will change
the setting of the previously recorded data. If you
want to cancel the setting change operation at this
point, release 3 FUNCTION.
(2) Press the G7 (Execute) keyboard key
• This will cause a short and then long beep to
sound, indicating that the operation is complete.
3.
Release 3 FUNCTION.
■ To delete a recorded performance
1.
While holding down the 3 FUNCTION button,
perform steps (1) and (2) below.
(1) Press the RECORDER CLEAR (E}6) keyboard key.
• This causes a short beep to sound.
• Note that performing step (2) below will delete the
previously recorded data. If you want to cancel the
delete operation at this point, release
3 FUNCTION.
(2) Press the G7 (Execute) keyboard key
• This will cause a short and then long beep to
sound, indicating that the operation is complete.
2.
Release 3 FUNCTION.
C1 C2 C3 C4 C5 C6 C7 C8
RECORDER SETTING key (D6)
G7 (Execute) key
C1 C2 C3 C4 C5 C6 C7 C8
RECORDER CLEAR key (E}6)
G7 (Execute) key