User manual - CP330PLUSver310_Soft

20060301
k
LIST Variable Element Operations
You can recall the value of any element of a LIST variable. When the values {1, 2, 3} are
assigned to “lista”, for example, you can recall the second value in the “lista”, when you need
it.
You can also assign a value to any element in a list. When the values {1, 2, 3} are assigned
to “lista”, for example, you can replace the second value with “5” to end up with {1, 5, 3}.
After performing the procedure under “Inputting List Data from the Work Area”, perform the
following operation.
u
ClassPad Operation
(1) Recall the value of the second element of LIST variable “lista”.
0lista9
[c]
w
2-5-2
List Calculations
(2) Assign “5” to the second element of LIST variable “lista”.
f
W0lista9
[c]
w
Tip
• You can also perform the above operations on the “ans” variable (page 2-2-2) when it contains
LIST data.
Example: {1, 2, 3, 4}
w
{1, 2, 3, 4}
D
[c]
w
2
k
Inputting List Data Using the Stat Editor Window
Tapping
(
displays the Stat Editor window, which you can then use to input list data. List
data input this way is assigned to a LIST variable, so you can access it by specifying the
applicable variable name.
For more information about using the Stat Editor window to create a list, see “7-2 Using Stat
Editor”.