User Manual

2-1

Basic Steps for Configuring Sampling Parameters

2 Basic Steps for Configuring Sampling

Parameters

This chapter explains the basic operations you need to perform when configuring Data

Logger sampling parameters from the E-CON3 application. Before performing any of the

procedures in this chapter, be sure to connect the Data Logger to your ClassPad.

Configuring Parameters for Sampling with a Single Sensor

Use the [Single] tab of the Sensor Setup window to configure the parameters for a single

sensor.

• The procedure for configuring sampling settings on the [Single] tab is similar to a Windows

Setup Wizard. As you select a sensor and input setting values on the [Single] tab, settings

are adjusted automatically in order to make it possible to perform sampling properly. Even if

you are configuring settings for a single sensor, you should use the [Multiple] tab when you

want to configure all of the detailed settings yourself.

To configure parameters for sampling with a single sensor

(1) Start up the E-CON3 application.

• This displays the [Single] tab of the Sensor Setup

window.

• If the E-CON3 application is already running and

another window (besides the Sensor Setup window)

is displayed, tap

to change to the Sensor Setup

window.