User Manual

7-1
Using the Multimeter Window
7 Using the Multimeter Window
The Multimeter window shows the sample values of all channels in real-time. You can also
use the Multimeter window to manually store sample data at any point.
Viewing Sample Data on the Multimeter Window
This section explains how to view sample data in real-time on the Multimeter window.
Tip
• Before performing the procedures described here, perform the preparation steps under “To get
ready for sampling” on page 5-1.
• Warm-up is not performed while you are using the Multimeter window for sampling.
• If the Multimeter window left on the display, sampling will terminate and the window will close
automatically after about five hours.
• Note that use of the Multimeter window is not supported when any of the following sensors is in
use.
• [CMA] - [Photogate]
• [CMA] - [Photogate (Pulley)]
• [CASIO] - [Microphone]
• [CASIO] - [Microphone-FFT]
• [CASIO] - [Speaker (Sample Data)]
• [CASIO] - [Speaker (
y
=
f
(
x
))]
• [Vernier] - [Photogate]
• [Vernier] - [Photogate (Pulley)]
• [Vernier] - [Microphone]