User Manual

9-8
E-CON Graph Window Operations
(4) On the dialog box, configure the settings as required.
Parameter Description
Graph Sheet
Specify a Graph Editor window sheet from Sheet 1 to Sheet 5 for
storage of the numeric expression that results from Fourier series
expansion. Note that any function expressions input on the sheet you
specify here are overwritten.
Start
Specify a value from 1 to 99 for the Fourier series expansion start
degree.
End
Specify a value from 1 to 99 for the Fourier series expansion end
degree. You can specify a start degree and end degree in the range of
0
<
End – Start
<
18. Specifying values outside of this range causes an
error.
View Window
The E-CON3 application uses View Window settings that are
independent of the View Window settings (
O
- [View Window]) for the
ClassPad Graph window.
This parameter specifies whether or not View Window settings of the
E-CON Graph Window (source graph) should also be applied to the
ClassPad’s View Window (result graph). The following explains the two
settings that are possible for this parameter.
Auto: This option overwrites the View Window settings of the
ClassPad with the View Window settings of the E-CON Graph
Window.
This setting makes it possible to apply the View Window
settings used to draw the source graph with Fourier series
expansion on the E-CON Graph window to draw a result
graph on the ClassPad Graph window using the function
obtained by Fourier series expansion.
Manual: Selecting this option causes the current ClassPad View
Window settings to remain unchanged.
In order to obtain a result graph that resembles the source
graph, make sure that the start point and end point that you
specify for the source graph is one period of the graph.
Start Point End Point