User Manual

Configuring Function Settings
EN-24
• Turning power off and back on again returns tone and other settings to their initial defaults (page EN-6).
• The settings below are retained even when power is turned off.
− MIDI Out Channel
− MIDI Out Octave Shift
− MIDI Out Velocity
− Startup volume level
− MY SETUP Startup
− Auto Power Off
− Battery type

Operation tone Off, On When this setting is disabled (Off),
a tone does not sound when a
keyboard key is pressed while
FUNCTION is depressed.

Demo Plays the Demo Song.

Metronome beat Off, 1 to 16 Changes the metronome beat. • To return the setting to its initial default,
press – and + at the same time.

Metronome
volume level
0 to 10 Changes the metronome volume
level.
• To return the setting to its initial default,
press – and + at the same time.

Sustain Off, On When enabled, sustains notes to
produce rich resonance.
• Each press of the keyboard key sounds a
tone that lets you know what setting was
selected.
High tone: On (enabled)
Low tone: Off (disabled)

Reverb Off, 1 to 4 Specifies the type of reverb to be
applied.
• Each press of the keyboard key sounds a
tone that lets you know what setting was
selected.
One low tone: Off (disabled)
One high tone: 1
Two high tones: 2
Three high tones: 3
Four high tones: 4

Transpose –12 to 0 to +12 The transpose feature raises or
lowers the overall pitch in
semitone steps.
You can use this feature to raise
or lower the key to make it easier
to play a piece written in a difficult
key, or to adjust to a key that
better matches a vocalist, another
musical instrument, etc.
• To return the setting to its initial default,
press – and + at the same time.

Tuning 415.5Hz to 440.0Hz to
465.9Hz
Fine tunes the overall pitch by
changing the frequency of A4 in
0.1Hz units.
Item Setting Options Description Remarks