Owner`s manual

Getting Ready
Save
Load/Copy
Delete
Initialize
Starting Up Tools
Error Messages
Use the procedure in this section to load a data file from your computer to
the Keyboard, or to save the data on a memory card or floppy diskette.
Note: Note that loading a data file to the Keyboard always overwrites the
existing corresponding data file in Keyboard memory. If you do not
want to loose the data file you currently have in Keyboard memory,
save it to your computer's hard disk before performing the load
operation.
When copying a data file from your computer to a memory card or
floppy diskette, any data file on the memory card or floppy diskette
that has the same name as the file being copied is replaced by the
newly copied file. If you want to keep the existing data file, be sure
to change its name before performing the copy operation.
If the "Memory Full" error message appears during a data load
operation, it means that Keyboard memory is full. See "Error
Messages" for information about what you need to do.
Note that a load operation loads one data file at a time. You cannot
load multiple data files using a single data load operation.
1. On the Keyboard tab, select the Keyboard.
2. Use the data selection boxes to select the type of data you want to
transfer.
3. In the PC data list, click the data file you want to transfer.
4. On the Keyboard data list, select the location (data file number)where
you want to load the data file.
If you do not specify a location, the data file will automatically be loaded
at the location specified by the file number at the beginning of its file
name.
5. Click the Load button.