Owner`s manual

Either click in the Tone boxes and type the Tone number, or right click and
select Tone from the pull down menu.
All other settings are entered either by clicking and typing the number or by
right clicking and using the plus / minus buttons or the plus 10 / minus 10
buttons for bigger changes.
Other items you can set for each keyboard part (UP1 / UP2 / LOW1 / LOW2
and Auto Harmonise) are:
volume
You can balance each part to create the finished
registration
pan
You can pan each part independently. (64 is center,
0 is hard left and 127 is hard right, and of course you
can select any panning location in between)
reverb
Sets the reverb send for each part
chorus
Sets the chorus send for each part
DSP
Sets whether DSP is on or off for each part (1=On / 0
= Off)
Oct.
Shifts the pitch of each part by +/- 2 Octaves
See the owner's manual of the Keyboard for the list of programe Change
numbers (Tone) and Bank Numbers (for Variation Tones).
Important Note: When you finally Save the pattern (CKF) the OTP data
will be saved with the pattern only if you have checked
the OTP On box