User Manual

11
To use the projector’s Setup Menu to configure network
settings
 Projector Operation
1. Press the [MENU] key to display the Frequent Functions Menu.
2. Press the [] key, select “Setup Menu”, and then press the [ENTER] key.
 This displays the Setup Menu.
3. Use the [] and [] keys to select “Network Settings” and then press the
[ENTER] key.
4. Use the [] and [] keys to select “Network Settings” and then press the
[ENTER] key.
5. Configure the settings you want.
6. After all the settings are the way you want, select “Update Network Settings”
and then press the [ENTER] key.
 This displays a confirmation dialog box asking if you want to update.
7. Use the [] and [] keys to select “Yes”, and then press the [ENTER] key.
 This restarts the network system. Restarting updates settings and then displays the network
standby screen.
To use the projector’s Setup Menu to initialize network settings
Note
 The procedure below can be used to initialize all items included in the “Network Settings” of
the projector’s Setup Menu. Though it also initializes most of the items included in “Projector
Setup” on the Web Service page (see “Projector Setting Items” on page 16), the items below
are not initialized.
Projector name, User List, Firmware
1. Perform steps 1 through 4 of the procedure under “To use the projector’s Setup
Menu to configure network settings” (page 11).
2. Select “Initialize Network Settings” and then press the [ENTER] key.
 This displays a confirmation dialog box asking if you want to perform initialization.
3. Use the [] and [] keys to select “Yes”, and then press the [ENTER] key.
 This restarts the network system. Restarting initializes settings and then displays the network
standby screen.