User Manual
Table Of Contents
- Contents
- Establishing a Network Connection Between a Computer and the Projector
- Configuring Projector Network Settings
- Using a Computer to Configure Projector Network Settings
- Preparing for C-Connection
- Network Projecting a Computer Screen Image (Using C-Connection)
- C-Connection Details
- Advanced Operations
- Ports Used for TCP/UDP
20
Network Settings
This page is for specifying the projector name and IP address.
This projector has two IP addresses, which are described in the table below. These IP addresses need
to be specified in accordance with the type of network connection being used.
LAN1 IP Address
The projector IP address when connecting the projector to an existing network. It corresponds to the
IP addresses described below.
IP address when the projector is connected wirelessly to an existing network in the Client Mode
(page 18)
You can select either a fixed IP address or auto acquisition of IP address depending on the type of
network being connected with. Network settings that need to be configured are those shown for
“Network Settings” 3 “LAN1 IP Settings” (page 21).
LAN2 IP Address
The projector IP address when connecting a computer by wireless LAN to a projector that is in the
Access Point Mode (page 17).
Network settings that need to be configured are those shown for “Network Settings” 3 “LAN2 IP
Settings” (page 21).
Use this item: To do this:
Projector name Specify a projector name (Initial Default: casiolpj0000000).
“0000000” is replaced by the seven characters from digit two to digit eight of the board
number. For example, if the board number is A2000311500254, the projector name will
be casiolpj2000311. For more information about the board number, refer to the
projector’s User’s Guide on the CASIO website.
If you want to manually input a projector name, input a character string up to 16
characters long into this input box. You can use numerals or alpha characters (upper
case or lower case), or single-byte symbols _, -, @.