User Manual

21
Note
 When inputting addresses for “IP Address” and “Default Gateway”, do not input leading zeros
for one-digit and two-digit octets (xxx parts of an address). For example, the following types of
input are not allowed: 029 for 29, 005 for 5, etc.
Note
 When inputting addresses for “IP Address”, “DHCP Server Start Address”, and “DHCP Server
End Address”, do not input leading zeros for one-digit and two-digit octets (xxx parts of an
address). For example, the following types of input are not allowed: 029 for 29, 005 for 5, etc.
Use this item: To do this:
LAN1 IP Settings
LAN1 IP Settings
(Auto if not checked)
Specify whether to use a manually specified fixed IP address or an IP address
automatically obtained from an external DHCP server when connecting the projector to
an existing network.
: Fixed IP address
: Automatically obtain IP address (initial default).
If you are using a fixed IP address, you also need to manually input information for the
settings from “IP Address” to “Default Gateway” below.
You do not need to input anything for the settings below if you selected the setting to
automatically obtain an IP address.
Note
 If you selected the setting to automatically obtain an IP address, the values
automatically assigned to the projector will not be displayed for the setting
items below.
IP Address Input a fixed projector IP address of the format below.
xxx.xxx.xxx.xxx (Initial Default: 192.168.20.1)
Subnet Mask Input a subnet mask of the format below.
xxx.xxx.xxx.xxx (Initial Default: 255.255.255.0)
Default Gateway Input a default gateway IP address of the format below.
xxx.xxx.xxx.xxx (Initial Default: 192.168.20.10)
Use this item: To do this:
LAN2 IP Settings
IP Address Input an IP address of the format below when using the projector as a wireless LAN
access point.
xxx.xxx.xxx.xxx (Initial Default: 192.168.100.10)
DHCP Server Start
Address
DHCP Server End
Address
Specify the start and end of the range of IP addresses to be automatically assigned to a
computer or smart device connecting to the projector via wireless LAN. Each address
must be the format below.
xxx.xxx.xxx.xxx (Initial Default: 192.168.100.11 to 192.168.100.200)
Regardless of the value that is input for “Subnet Mask” below, the first three octets
(Initial Default: 192.168.100) of the start and end addresses must be the same.
Subnet Mask Input a subnet mask of the format below.
xxx.xxx.xxx.xxx (Initial Default: 255.255.255.0)