User Manual

5
Establishing a Network Connection Between a
Computer and the Projector
To start network projection from a computer, there must be a network connection between the
computer and projector.
With this configuration, the projector is used as a wireless LAN access point. A computer connects
directly to the projector via a wireless LAN network connection.
Note
 Wireless connection requires use of the YW-41 wireless adapter, which may have been
provided with your projector or which you may need to purchase separately. For information
about whether or not the wireless adapter is included with your projector, refer to “Unpacking”
in the User’s Guide that is available from the CASIO website.
 You can have up to eight computers and/or smart devices connected to a single projector at
the same time over a wireless LAN.
To connect the projector and a computer via wireless LAN
1. Connect the wireless adapter (YW-41) to the projector.
 For details about adapter connection, refer to the user documentation that comes with the
projector.
2. On the projector’s network standby screen (page 6), note the projector SSID.
3. On the computer, connect to the projector SSID via wireless LAN.
 See the sections below for information about how to prepare for and perform network
projection from your computer.
– “Preparing for C-Connection” (page 23)
– “Network Projecting a Computer Screen Image (Using C-Connection)” (page 26)
Establishing a Direct Wireless LAN Connection
Between a Computer and the Projector
Projector
Wireless LAN connection