User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- About the Light Source Unit
- Do not block light output or look directly into the lens!
- Laser Precautions (See the label on the projector)
- AC Adapter Precautions
- Battery (Optional YA-B10) Precautions
- Soft Inner Case (Optional YB-3) Precautions
- Other Precautions
- Precautions when Handling the Projector after Use
- Getting Ready
- Operating the Projector
- Cleaning the Projector
- Troubleshooting
- Appendix
- Specifications
71
Indicator Status When an Error Occurs
Fan error
Power has turned off automatically due to a fan problem. Confirm that the POWER/STANDBY
indicator is lit red (without flashing) and that the fan has stopped. After checking the POWER/
STANDBY indicator, disconnect the AC adapter (or battery) from the projector and wait for all of the
projector’s indicators to go out. Next, reconnect the AC adapter (or battery) and turn projector power
back on. If the error occurs again when you turn power back on, contact your retailer or nearest
authorized CASIO Service Center.
System Errors and Other Operation Problems
The projector was automatically turned off because of a system problem or because of an operational
problem caused by external noise. After confirming that the POWER/STANDBY indicator is lit red
(without flashing), disconnect the AC adapter (or battery) from the projector and wait for all of the
projector’s indicators to go out. Next, reconnect the AC adapter (or battery) and turn the projector
back on. If the error occurs again when you turn power back on, contact your retailer or nearest
authorized CASIO Service Center.
Light Source Unit Problems
The projector was turned off automatically because the light source unit turned off or did not turn on.
After confirming that the POWER/STANDBY indicator is lit red (without flashing), disconnect the AC
adapter (or battery). Wait for a short while and then reconnect the AC adapter (or battery) and turn on
the projector again. If the error occurs again when you turn power back on, contact your retailer or
nearest authorized CASIO Service Center.
Memory Error
Power has turned off automatically due to a projector memory error. Confirm that the POWER/
STANDBY indicator is lit red (without flashing). After checking the POWER/STANDBY indicator,
disconnect the AC adapter (or battery) from the projector and wait for all of the projector’s indicators
to go out. Next, reconnect the AC adapter (or battery) and turn projector power back on. If the error
occurs again when you turn power back on, contact your retailer or nearest authorized CASIO Service
Center.
POWER/STANDBY : Lit red
STATUS : Flashes amber (Approximately 0.5-second intervals)
POWER/STANDBY : Lit red
STATUS : Lit red
POWER/STANDBY : Lit red
STATUS : Flashes red (at approximately 1-second intervals)
POWER/STANDBY : Lit red
STATUS : Flashes red (at approximately 2-second or 1-second intervals)