User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- About the Light Source Unit
- Do not block light output or look directly into the lens!
- Laser Precautions (See the label on the projector)
- AC Adapter Precautions
- Battery (Optional YA-B10) Precautions
- Soft Inner Case (Optional YB-3) Precautions
- Other Precautions
- Precautions when Handling the Projector after Use
- Getting Ready
- Operating the Projector
- Cleaning the Projector
- Troubleshooting
- Appendix
- Specifications
26
Bottom/Left Side
General Guide
*1 The anti-theft lock hole is provided for connection of an anti-theft chain. Visit the Kensington Lock
Website at https://www.kensington.com/
for more information.
*2 1/4-20 UNC screw. Note the following points when mounting the projector on a tripod.
The allowable screw height is 4 mm to 5.5 mm. Use of a screw with a height that exceeds
5.5 mm can damage the projector.
Make sure that the tripod you are using is strong enough to support the projector. A tripod that
is not strong enough can tip over, creating the risk of accident and personal injury.
Do not leave the projector mounted on the tripod when moving them to another location. Doing
so creates the risk of accident and personal injury.
When mounting the projector on a tripod, make sure you first fully close the tilt foot. An open tilt
foot can come into contact with the tripod, which can damage the tilt foot.
Key and indicator panel
Wireless adapter case (Network model only)
HDMI terminal
LOGO
Security lock hole*
1
Speaker (Network model only)
Zoom ring
Focus ring
Projection lens
Exhaust vents
Tripod screw hole*
2
Tilt foot
DC IN terminal
(Polarity of DC power connector)