User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- About the Light Source Unit
- Do not block light output or look directly into the lens!
- Laser Precautions (See the label on the projector)
- AC Adapter Precautions
- Battery (Optional YA-B10) Precautions
- Soft Inner Case (Optional YB-3) Precautions
- Other Precautions
- Precautions when Handling the Projector after Use
- Getting Ready
- Operating the Projector
- Cleaning the Projector
- Troubleshooting
- Appendix
- Specifications
38
3.
Adjust the tilt angle while checking the result on the projection screen.
Important!
Close the tilt foot before moving the projector to a different location.
Never use the tilt foot as a carrying handle when transporting the projector. Doing so can
damage the tilt foot and/or projector, and can cause the projector to fall.
Do not try to force the tilt foot any further than it will naturally go. Doing so can damage the tilt
foot and/or projector.
Use a conveniently located power outlet that you can reach easily when you need to unplug the
projector.
Airflow from air conditioning equipment can blow the heat being exhausted from the area around
the projector’s lens in a way that causes heat ripples to appear in the projected image. If this
happens, adjust the airflow of the air conditioning equipment or move the projector.
Do not locate the projector where ventilation is poor or in a sealed environment.
– When a battery is connected to the projector, avoid keeping the battery on the side of the
projector that has exhaust vents. Keep the battery at least 5 cm (2 inches) away from the
projector.
Setup Precautions
E