User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- About the Light Source Unit
- Do not block light output or look directly into the lens!
- Laser Precautions (See the label on the projector)
- AC Adapter Precautions
- Battery (Optional YA-B10) Precautions
- Soft Inner Case (Optional YB-3) Precautions
- Other Precautions
- Precautions when Handling the Projector after Use
- Getting Ready
- Operating the Projector
- Cleaning the Projector
- Troubleshooting
- Appendix
- Specifications
58
Input Settings 3 HDMI
Equalizer
Configure equalizer settings for the HDMI input signal. Normally the “Auto*” setting
should be used. However, if you experience problems projecting an HDMI signal or if
image noise is generated, you can change this setting to a value from 1 to 5.
Changing this setting will close the Setup Menu.
Input Settings 3 HDMI
Input Range
Specify the input range setting of the HDMI input signal. If a maladjusted black level,
blocked up shadows, or blown-out highlights are present in the HDMI input signal’s
image, try changing this setting.
Auto*: Automatic input range detection
Limited: Adjusted to DVD signal level
Full: Adjusted to computer signal level
Input Settings 3
Signal Name Indicator
Specify whether or not the signal name should be shown in the projection image.
On*: Signal name shown.
Off: Signal name not shown.
Input Settings 3
Restore Menu Defaults
Return all of the items in the “Input Settings” menu to their initial defaults for the
currently projecting image source.
Option Settings 1 3
Auto Keystone Correction
Enable (On*) or disable (Off) auto keystone correction in accordance with the angle
of the projector.
Note
This setting item cannot be selected and auto keystone correction is
disabled while the “On” is selected for “Screen Settings 3 Ceiling Mount”.
Option Settings 1 3
Light Control
Adjust light output.
For details, see “Adjusting Projection Brightness (Light Control)” (page 48).
Option Settings 1 3
Bright Mode
See “Bright Mode (Maximum Brightness)” (page 49).
Option Settings 1 3
Auto Power Off
Specify the amount of time of projector operation and input signal inactivity to be
allowed before Auto Power Off is triggered to turn off projector power automatically.
Auto Power Off can be disabled, if you want.
5 min, 10 min*, 15 min, 20 min, 30 min: Time until Auto Power off is triggered.
Off: Disables Auto Power Off.
Note
You can change the Auto Power Off setting only while the projector is being
powered by the AC adapter. The Auto Power Off setting is always five
minutes while the projector is being powered by a battery. The setting
cannot be changed.
During battery-powered operation, the projector will turn off if no key
operation is performed and there is no input signal to the projector for
about five minutes, regardless of the current Auto Power Off setting.
Option Settings 1 3
Password
Configure password settings.
For details, see “Using a Password” (page 66).
Option Settings 1 3
Direct Power On
Enable (On) or disable (Off*) projector auto power on as soon as the AC adapter
connected to the projector is plugged into a power outlet.
Option Settings 1 3
Language
Specify the display language.
English, French, German, Italian, Spanish, Swedish, Portuguese, Dutch, Norwegian,
Polish, Finnish, Czech, Turkish, Russian, Lithuanian, Vietnamese, Thai, Malay,
Indonesian, Arabic, Chinese (Simplified), Chinese (Traditional), Korean, Japanese
Important!
Network Model Users
When using certain Network model functions, some menus and messages
may be displayed in English, regardless of the language selected here.
Use this menu item: To do this: