User Manual
Table Of Contents
- Contents
- Safety Precautions
- Operating Precautions
- About the Light Source Unit
- Do not block light output or look directly into the lens!
- Laser Precautions (See the label on the projector)
- AC Adapter Precautions
- Battery (Optional YA-B10) Precautions
- Soft Inner Case (Optional YB-3) Precautions
- Other Precautions
- Precautions when Handling the Projector after Use
- Getting Ready
- Operating the Projector
- Cleaning the Projector
- Troubleshooting
- Appendix
- Specifications
42
You can use the optionally available wireless remote controller (YT-161) to perform projector
operations. Point the remote controller signal emitter at the signal receiver on the projector as you
perform remote controller key operations. The maximum range of the remote controller signal is
approximately 5 meters (16.4 feet) (between signal emitter and receiver).
Important!
To avoid running down the batteries, store the remote control unit so its keys are not pressed
inadvertently.
Note
Depending on your projector model, certain remote controller keys are disabled.
CX-E1: Gray shaded keys, plus [INPUT], [VOLUME +], and [VOLUME –]
CX-F1: Gray shaded keys
Specifications are subject to change without notice.
Optionally Available Remote Controller
Remote control signal emitter
Turns power on or off.
Press to exit the currently displayed menu or to cancel an
operation.
Use the cursor keys ([][][][]) to move between menu
items, and to change setting values. Press the [ENTER] key to
select a menu item or to execute a function.
Press each of these keys to execute their functions. For
information about the function of each key, see “Operating the
Projector” (page 43).