MA0402-EB Operation Guide DQR-300U Main unit Sub-unit 1 F SELECT °C/ °F RESET TEST C CASIO D SELECT °C/ °F RESET TEST E 5 SNZ ON OFF ALM SNZ ON OFF ALM HUMIDITY MAX/MIN TEMP. MAX/MIN CLEAR SET UP( +) DOWN(—) 8 3 2 A B HUMIDITY MAX/MIN TEMP.
Operation Guide DQR-300U • A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the clock. • Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the illustration. Alarm Off Current time (Hour, minutes, seconds) Alarm On Snooze on indicator Day of the week GENERAL GUIDE Main unit 1 SNOOZE/LIGHT button • Press this button to illuminate the display for about four seconds.
Operation Guide DQR-300U TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS USING THE CLOCK • This clock is able to receive the time calibration signal transmitted from Rugby Rugby, England. Signal reception is possible within approximately 1,000 kilometers 1,000 km of the transmitter. • Even when the clock is within the reception range, signal reception is impossible if the signal is blocked by mountains or other geological formations between the clock and signal source.
Operation Guide DQR-300U 2. While the screen you want is on the display, use the Alarm Time Set buttons (2) to change the digits that are flashing. BATTERY REPLACEMENT Low Battery Warning Press + to increase the flashing digits. +) UP( DOWN(—) Press — to decrease the flashing digits. • Holding down + or – changes the flashing digits at high speed. • You can set the year in the range of 2000 to 2039. The day of the week is set automatically in accordance with the date setting.
Operation Guide DQR-300U Switching between Main Unit and Sub-unit Temperature Data • Press the SELECT button (B) to toggle the display between the main unit (INDOOR) temperature and the subunit (OUTDOOR) temperature. Main unit temperature: INDOOR indicator displayed Sub-unit temperature: OUTDOOR indicator displayed • The display does not change to the sub-unit (OUTDOOR) temperature if no data has been received from the subunit yet.
Operation Guide DQR-300U • To clear the high humidity and low humidity data memory, press the CLEAR button (9). New data starts to be stored after memory is cleared. USING THE WEATHER FORECAST FEATURE A built in pressure sensor makes it possible to forecast upcoming weather over the next 12 hours based on changes in barometric pressure. Note that these forecasts are not absolutely accurate, and are intended for general reference only.