User manual - DT-810M50RC

E-26
Before Using the Data Collector for the First Time
Be sure to perform the reset operation described below before using the Data Collector for
the first time after you purchase it.
Make sure Data Collector power is turned off.
↓
Use a paper clip or some other thin object to press the RESET button.
↓
Perform touch panel alignment.
↓
The system menu starts up.
Important! • The above procedure needs to be performed only before you use the
Data Collector for the first time after purchasing it, or after memory
contents are deleted due to the main battery and the backup battery
going dead or being removed at the same time. If the RESET button is
pressed accidently, you must complete the other steps of the above
procedure to reset the Data Collector.
↓
Perform a RAM drive check. If the drive is not
formatted, display the check screen and format it.
Aligning the Touch Panel Position
Always correctly align the touch panel position.
Failure to do this may cause problems. For instance ...
— the display might not match the position you touched
— the display might not show the same characters you entered
So set correctly and promptly realign the touch panel if position errors occur.
HOW TO ALIGN THE TOUCH PANEL
1 Finish any on-going job and turn off the
power.
2 Display the SYSTEM MENU as follows.
Press
PW
while holding down
FNC
and
to start up the SYSTEM MENU.
3 Press to select the touch panel
CALIBRATION menu.
SYSTEM MENU
1 : EXECUTE AP
2 : SET MODE
3 : DATE / TIME
4 : TRANSMIT
5 : CALIBRATION
6 : VERSION
7 : SS UTILITY