User manual - DT-810M50RC

E-28
Performing a Bar Code Read Operation
1 Turn on the Data Collector, position the reader
port close to the bar code you want to read,
and then press the trigger key.
2 The reader port emits a laser to read the bar
code. The read indicator lights green when the
read is successful.
Important! • If you have problems with the read operation, change the angle between
the label and Data Collector, or move closer and then try again.
• If the bar code is larger than the diameter of the Data Collector’s reader
port, try moving the Data Collector a bit farther away from the bar code.
• The Data Collector should be able to read a bar code from the maximum
distance of 38 centimeters under the following conditions.
Ambient Light: 500 lux (fluorescent)
PCS: 0.9 min.
Minimum Bar Width: 1.2 mm
ITF (extended version)
• Wavelength: 670 nm
Maximum output: 1.0 mW
• CAUTION
Use of controls or adjustments or
performance of procedures other
than those specified herein may
result in hazardous radiation
exposure.
Using the Bar Code Reader
EXPLANATORY LABEL
Maximum distance:
Approximately 38 cm
(Normal Mode)
Reader port
Read indicator
Trigger key
Power key
CLASS 1
LASER PRODUCT